Jd1020 hydraulic problems

[Workin fool]

I can turn both shafts by hand. Thanks for heads up on washers and tool That tool doesn’t come cheap. But while I’m in there might as well change it.

 

[Workin fool]

Does anyone have a parts number for packing or seals for the low pressure lines going to the housing on jd 1020

 

[Tx Jim]

If you need packings for hyd lines that insert into clutch housing they're part # R1662R

https://partscatalog.deere.com/jdrc/sidebyside/equipment/75128/referrer/navigation/pgId/249470

 

[Zebrafive]

I can turn both shafts by hand. Thanks for heads up on washers and tool That tool doesn’t come cheap. But while I’m in there might as well change it.

See if your dealer will loan/rent you the tool. My dealer loaned me their tool, but that was over 20 years ago, before a Mega dealer bought them out.

 

[Zebrafive]

You may as well also buy the gasket, O-rings/packing for the clutch housing to transmission case split. Not knowing your serial number, I did not list P/Ns

 

[Tx Jim]

workin fool
I hope your tractors engine serial # is above 035895- because rear main seal for lower serial # costs $387.75 when procured from JD.

 

[Workin fool]

workin fool
I hope your tractors engine serial # is above 035895- because rear main seal for lower serial # costs $387.75 when procured from JD.

 

[Workin fool]

Yes serial number is 79000. Thanks for everyone’s help

 

[Tx Jim]

Yes serial number is 79000. Thanks for everyone’s help

""ENGINE NOT tractor serial #"" determines engine rear seal part #

 

[Workin fool]

You are right Jim. Engine is 123000,

 

[Tx Jim]

You're lucky your tractor engine doesn't require the high $$$$ seal