installing gauges

[speedy2]

Is it a good idea to pull fuel tank on ym1500 to get to the back of the dash to install oil pressure and temperature gauges? Thanks Speedy2

 

[reb]

Didn't have to on mine. There is plenty of room to work with everything in place.

 

[damammel]

Nope. Plenty of room to work on the 1500. I've installed battery volt, oil and temp on mine. Only thing I did was pull the steering wheel to drill the holes.

 

[Neat 1500]

Nope. Plenty of room to work on the 1500. I've installed battery volt, oil and temp on mine. Only thing I did was pull the steering wheel to drill the holes.

i didnt even pull the wheel! i found more than enough room to drill and work

 

[Smoody]

I was able to drill holes and work with everything in place as well, ym2210

 

[BC Dave]

i didnt even pull the wheel! i found more than enough room to drill and work

... if you have small hands! ....

although I have not installed new gauges on my 180D; and Id like to; its a good idea; I have had the front plastic dash off to repair wiring; I could not access the wires properly with it in place and never managed to get the steering wheel off after much WD40; puller, grunting and even tried hammering a chisle between the steering wheel and the housing to no sucess ... only reason I got it off was it was a broaken dash at the steering wheel.