How to remove this fuel filter?
- Thread starter ning
- Start date
- Views: 8404
Outlawmoon
Member
I have that on my tractor.... I've used a strap wrench for the past five years...no problems getting it off and on.
Tony H
Platinum Member
It looks so nice and easy until you realize the two rubber lines run right down the ring making spanner or channel lock fit nicely. How'd you make out?
Williy
Elite Member
- Joined
- Apr 26, 2020
- Messages
- 3,625
- Location
- Texas
- Tractor
- Yanmar YT 235C Yannar YRC 60 rotary cutter, Yanmar RT72 rotary tiller B75 Backhoe & bucket & thumb, LS land grader
Some filters are make so you can use these I
like them. Put your ratchet on cup type and presto
just like removing a bolt
willy
like them. Put your ratchet on cup type and presto
just like removing a bolt
Amazon.com: AMPRO T75871 Cup Type Oil Filter Wrench Set, 14-Piece : Automotive
Buy AMPRO T75871 Cup Type Oil Filter Wrench Set, 14-Piece: Oil Filter Wrenches - Amazon.com ✓ FREE DELIVERY possible on eligible purchases
www.amazon.com
willy
RickB
Super Star Member
- Joined
- Sep 18, 2000
- Messages
- 15,190
- Location
- Up the road from Dollar General WNC
- Tractor
- Just a Scag
That's great when the part the cup grips is threaded. This one isn't. Good in this instance for breaking the bowl and wadding up the o-ring if you're unlucky enough to have the cup actually fit the bowl.
bartjoebob
Silver Member
Channel locks 1/4 turn counter clockwise. Loosen by hand from there. The cup will likely stick in the housing because the o ring is old and compressed. Don't forget new o ring when reinstalling. Leave the aluminum ring a little loose and turn ignition to prime fuel through the cup. The you can probably hand tighten