bobgshn
New member
I have a craftsman 18 HP 42" lawn tractor and it is cutting higher on the left side I have the height adjustment on 6 but it cuts the grass at 3". Can anyone help me?
How do I adjust mower deck?
- Thread starter bobgshn
- Start date
- Views: 2484
Welcome to TBN. 
mguitas
Super Member
- Joined
- Aug 22, 2011
- Messages
- 8,080
- Location
- Schuylkill County Pennsylvania
- Tractor
- Massey Ferguson 1423 Hydrostat
:welcome: check with your manual. There should be something about height adjustment.
Briana03
Elite Member
WELCOME to TBN
I moved your thread to the General Lawn & Garden Forum.
I moved your thread to the General Lawn & Garden Forum.
KennyG
Elite Member
If it's like all the other Craftsman mowers I have seen, the deck is supported by a linkage on each side. Each one is independently adjustable so you can level it and overall raise or lower it so you get a usable range of heights with the controls.
paulemar
Silver Member
- Joined
- May 26, 2011
- Messages
- 185
- Location
- Pittsburgh, PA
- Tractor
- Kubota BX25, 60" MMM, 3 point hitch
KennyG said:
In addition to the above, make sure that the air pressure in the tires is correct. A low tire will give you an uneven cut.
tracter
Silver Member
Adjust the linkages to get side to side level (blades pointing east/west) , then blades pointing north/south adjust the cut , the leading edge of the blade should be no more than 1/8 to 1/4 of an inch lower than the trailing edge , set like that will give a nice clean cut :thumbsup:
