Popgadget
Elite Member
Good Morning.
It’s 74 and going to 84 with chance of rain and thunderstorms.
Yesterday looked like rain all day, but stayed dry. I cleaned up quite a bit in the shop, quite a bit of time around the welding table, getting ready for the arrival of the new TIG machine. Ended up disassembling the Miller Radiator torch cooler to clean it out and flush the coolant lines because it had restricted flow. Turned out to be the suction screen inside the tank. Of course the irony is that the new machine comes with an air cooled torch.
Today will start off in the shop, but might end up in Lexington, KY. There’s a fair chance I’ll have to go late this afternoon and return tomorrow. With that in mind, I ought to get moving and head over there and get started.
On the subject of greasing, it’s interesting how different the design of my mowers is. As I mentioned the Exmark has two fittings that take a couple pumps every couple of months. The 3PT LandPride finish mower gets the casters, spindles and U Joints greased for a total of 9 fittings every 10-15 Hours. The big Progressive pull behind mower has at least 50 fittings and takes about a tube of grease every 10 hours. Couldn’t imagine keeping it greased without a cordless grease gun.
I will reach out Ken, as it turned out I never made it yesterday, I never made it yesterday, went down a rabbit hole in the shop with the TIG cooler. But they have a recurring Sunday afternoon gig there.
It’s 74 and going to 84 with chance of rain and thunderstorms.
Yesterday looked like rain all day, but stayed dry. I cleaned up quite a bit in the shop, quite a bit of time around the welding table, getting ready for the arrival of the new TIG machine. Ended up disassembling the Miller Radiator torch cooler to clean it out and flush the coolant lines because it had restricted flow. Turned out to be the suction screen inside the tank. Of course the irony is that the new machine comes with an air cooled torch.
Today will start off in the shop, but might end up in Lexington, KY. There’s a fair chance I’ll have to go late this afternoon and return tomorrow. With that in mind, I ought to get moving and head over there and get started.
On the subject of greasing, it’s interesting how different the design of my mowers is. As I mentioned the Exmark has two fittings that take a couple pumps every couple of months. The 3PT LandPride finish mower gets the casters, spindles and U Joints greased for a total of 9 fittings every 10-15 Hours. The big Progressive pull behind mower has at least 50 fittings and takes about a tube of grease every 10 hours. Couldn’t imagine keeping it greased without a cordless grease gun.
I will reach out Ken, as it turned out I never made it yesterday, I never made it yesterday, went down a rabbit hole in the shop with the TIG cooler. But they have a recurring Sunday afternoon gig there.