Good morning!!!!

   / Good morning!!!! #56,631  
Maybe it is time for some bananas in the front end housing and a for sale sign on it?

Well. That rust bucket and I have seen some really bad time together. If there ever was a tractor that was abused, it is my tractor. After the first hurricane, I was so busy so I just let the dealer fixed it. Come find out much later they did a piss poor job. I've used my tractor practically as a dozer to clean up 33,000 yep 33 thousand cubic yards of debris that floated onto my land after the two hurricanes. The debris actually included 3 float away houses that landed on my property. Then I used it for hours and hours to move 450 cubic yards of dirt to repair my house pad. Hours and hours of service with very little TLC that it deserves. Now that one front leg is essentially crippled. I'm just going to button it up and use it as a 2WD until I have some free time this winter.

Yup, it is a mange but it is my dog of a tractor :) I wish I have the time to treat it a little better but as it is both it and I will have to tough it out this year until I get my house in a better shape.
 
   / Good morning!!!! #56,633  
Have you a reason to change the oil? If your tractor isn't too old, metal shavings aren't unusual in engines.

The bevel case sprung a leak at the right bottom cap. I noticed the leak and investigated. What I found were not shavings. They are rather chunks that are 1/8" thick. I'm pretty sure my bevel gears are shot. However, the shaft and bearings appear solid and there's no leak through the seals.
 
   / Good morning!!!! #56,634  
Good morning, overcast and slightly damp this morning, with high chance of showers on and off all day.

Have grandson coming soon, so to speed things up a little I used the old Subaru to get around the sheep in most fields. The battery struggled to find enough amps to get the starter motor to turnl. Fortunately the eager to please engine didn't hesitate to take the hint that I wanted it running. I really should find time to track down what is pulling power - or at least make arrangements to keep it on continuous charge if it stands more than a couple of days without use.


Mostly, pinched tubes are a pain. I once got a freebie set of cheap plastic tire levers with a magazine subscription. Not sure if they were cleverly designed or just plain lucky, as I never pinched a tube with them, unlike the metal ones I had been using before.


Well. That rust bucket and I have seen some really bad time together. If there ever was a tractor that was abused, it is my tractor. After the first hurricane, I was so busy so I just let the dealer fixed it. Come find out much later they did a piss poor job. I've used my tractor practically as a dozer to clean up 33,000 yep 33 thousand cubic yards of debris that floated onto my land after the two hurricanes. The debris actually included 3 float away houses that landed on my property. Then I used it for hours and hours to move 450 cubic yards of dirt to repair my house pad. Hours and hours of service with very little TLC that it deserves. Now that one front leg is essentially crippled. I'm just going to button it up and use it as a 2WD until I have some free time this winter.

Yup, it is a mange but it is my dog of a tractor :) I wish I have the time to treat it a little better but as it is both it and I will have to tough it out this year until I get my house in a better shape.

CajunRider, it doesn't sound like you want to part with one another after living through all that. The real test on how much you love your tractor will come one day when you get another one. I fully intended to sell my old tired Fergie when I got my Iseki, but more than 2 years on and it's still with me. It is a little jealous though and insists on getting my attention now and again by pretending it has a sickly part until I get the old imperial sized spanners out.
 
   / Good morning!!!! #56,635  
Hawkeye, sounds like your wife had a nasty cut. Hope it doesn't throb too much now the painkillers have worn off and she responds to all the pampering you no doubt will be treating her to.
 
   / Good morning!!!! #56,636  
47 going to 68 and no rain after an inch yesterday.

CJR, sounds like you have had to endure quite a lot during that storm to have that much residue to clean up.

Eric, have fun with your grandson.
 
   / Good morning!!!! #56,637  
26 and going to a high of 48, wind NNE 6 mph.
My PC went for a dump and now I am on my laptop. PC should be back up and running by tomorrow. IF all goes well.
 
   / Good morning!!!! #56,638  
On 2nd cup of coffee and 60 degrees here in SE Oklahoma.
Slide and swing are ready for granddaughter. Along with new pink bicycle in garage. Have to leave out soon to go get them at airport.
Moved all the implements around to behind shed and cleaned up shop yesterday and "kid safeties" everything.
Which brings up a point of contention with me and Her Highness.
As I went to open the 15 bags of mulch for the slide, I remembered that I had an old stainless handled knife laying at other end of deck that I use for cutting seed potatoes, gardening stuff, etc. That knife has stood firmly up between two deck boards in that little out of the way place for the 8 years we've lived here.
And it was gone! So now I am diverted into a "where the **** did I leave that?" game that sucks more and more of my time as I get older it seems. Finally, wife looks out window asking me what I'm searching for. After I tell her, she says, "Oh I picked that up and put it away yesterday. You can't leave that out where that little girl can cut herself !" " You should know better"
Been married ten years next week and she knows moving something on me without me knowing irks my *** and I swear she does it just to watch me bird dog all over the place looking for missing items!
 
   / Good morning!!!! #56,639  
47 high of 67 later enjoyable bike ride with wife yesterday evening

Off to retrieve Z Turn this morning let the mowing begin
 
   / Good morning!!!! #56,640  
2017-04-01, 0815

32 and snowing right now....so far, I'd estimate we got about 10" with another 3" coming down before it's done. High will be mid-to upper 30's.
Obviously, my plans today will be clearing the drive, back deck and walks. After that...we'll see...

I guess New England got Mama Nature's April Fool's Day trick
 

Tractor & Equipment Auctions

2019 Ford Explorer AWD SUV (A50324)
2019 Ford Explorer...
2022 CATERPILLAR 306CR EXCAVATOR (A51242)
2022 CATERPILLAR...
2018 Toro Sand Pro Bunker Rake with Edger Broom (A49461)
2018 Toro Sand Pro...
2016 PETERBILT 587 (A50854)
2016 PETERBILT 587...
2014 VOLVO VNM DAY CAB (A51222)
2014 VOLVO VNM DAY...
2025 Unused International MV607 Truck TMA Attenuator Truck (A49461)
2025 Unused...
 
Top