Ford 2 N

[slim357]

Does the camshaft just slide out or is it held in by something else?

 

[John0829]

It will slide out just make sure all the tappets are up against the block so one of them does not hang on the cam as you try to remove it. I usually flip the block upside down before removing the cam. On a side note there are NO cam bearings if that is the reason you are removing it thinking to replace them.

 

[slim357]

It will slide out just make sure all the tappets are up against the block so one of them does not hang on the cam as you try to remove it. I usually flip the block upside down before removing the cam. On a side note there are NO cam bearings if that is the reason you are removing it thinking to replace them.

Thanks for the information. Lifters are all rusted in place, I got them to each move to top of lobe so hopefully will come out