Flashing light on bx23

[glennm]

I have an old orange flashing light ( the kind with a rotating reflector) that I want to use on the bx roll bars when I am moving snow. Any suggestion as to where I should take the power from? I was hoping there was something under the seat but I don't see anything? Also, do you think a magnet would work to hold it in place?

 

[chim]

A really strong magnet might work, but when I tried that approach on the B7500 I had, the magnet wasn't strong enough to keep the light in place. Since the tractor lacks a suspension the ROPS makes sharp movements when the tractor hits a bump. I now bolt everything to the tractor that needs to stay put.

 

[oldballs]

The may be a power source under one of the fender tail lights that's meant to be used for your hookup.... as I recall.

 

[PeterK]

Should be a work light connector, red and black wires just rear of the bottom of the seat, over the tank. Check for 12V with a meter. It is switched on with ignition as I recall.

 

[glennm]

Found the wire under the seat. Worked out great. Thanks!

 

[teamorange7]

Try the welding magnets from harbor freight . I use them on bx24 for lights on roll bar. No problem

 

[glennm]

Has anyone put an LED light bar on the roll bar to use a a work light?

 

[RaydaKub]

Has anyone put an LED light bar on the roll bar to use a a work light?

4shorts has. Look for his bx25 mod thread.

 

[rdsaustintx]

Should be a work light connector, red and black wires just rear of the bottom of the seat, over the tank. Check for 12V with a meter. It is switched on with ignition as I recall.

That's where the hook-up is. It switches on with the headlights tho

 

[4shorts]

Has anyone put an LED light bar on the roll bar to use a a work light?

Yup


Front led light bar .

Rear, white and amber led 70 pattern strobe