40_acre_mule
Silver Member
I bought a Land Pride Finish mower FDR 1672 back in 2005. Served me well even though I was a little rough on it as I developed my property.
In 14 years, I think I only bent two wheel yokes (able to press them straight), and never replaced a wheel.
I let it go when I sold the old Kubota in 2019, but immediately replaced it. The areas I'm mowing are finished up now and far easier on the machine.
Now, in only four years, I've bent three yokes and just busted a wheel. These assemblies seem to be made from much more inferior materials then before.
I don't want to just get the same old cheap stuff.
Can any of y'all recommend a more robust yoke/wheel with which to replace them?
It has a 1 inch shaft.
In 14 years, I think I only bent two wheel yokes (able to press them straight), and never replaced a wheel.
I let it go when I sold the old Kubota in 2019, but immediately replaced it. The areas I'm mowing are finished up now and far easier on the machine.
Now, in only four years, I've bent three yokes and just busted a wheel. These assemblies seem to be made from much more inferior materials then before.
I don't want to just get the same old cheap stuff.
Can any of y'all recommend a more robust yoke/wheel with which to replace them?
It has a 1 inch shaft.