Beltzington
Platinum Member
While rewiring my trailer I applied 12VDC to test each brake, this one did nothing. How do they work and where can I get parts? TIA
Electric Brakes - INOP
- Thread starter Beltzington
- Start date
- Views: 2139
Willl
Elite Member
#1 is your electric magnet that when activated gets attracted to the inside surface of your 'moving' drum. This pulls the magnet to the right or left, can't tell in this pic.
#2 is the arm that the magnet is attached to and gets push to the right/left by the magnet.
#3 is a 'cam' that rotates from the arm movement and spreads the top portion of the brake shoes apart.
Chances are your magnet can be replace by itself.
Last edited:
Willl
Elite Member
Egon
Epic Contributor
For some types of axles you can get bolt on replacement brake units. These are almost as inexpensive as doing the replacement piecemeal.
Try Goggling Dexter axles and check out some sites.
I have purchased the Dexter brake replacement components at an RV dealer.
Try Goggling Dexter axles and check out some sites.
I have purchased the Dexter brake replacement components at an RV dealer.
OP
Beltzington
Platinum Member
Wow! - Great Video.
After this explanation I'm going to clean all the rust from my brakes components and see if it works. If not I will replace the magnet. Thanks very much for the quick replies.
After this explanation I'm going to clean all the rust from my brakes components and see if it works. If not I will replace the magnet. Thanks very much for the quick replies.
firedog
Gold Member
Egon is right, in many cases it is just a cheap to replace the entire brake/hub assembly. check out: Trailer Parts Superstore - Recreational & Commercial Trailer Parts Dealer Since 1981
I recently replaced the entire set on 5th wheel, it was about the same price for the whole unit as it was for the shoes & magnets.
I recently replaced the entire set on 5th wheel, it was about the same price for the whole unit as it was for the shoes & magnets.
Treemonkey1000
Veteran Member
Me being the electronic geek that I am wouldn't use those Scotch locks as shown in the video. I have had too many of them corrode over the years and not make good connections. I soldered my wires together to the brake wires. Just my two cents worth of wisdom.
Here are some similar links:
