Cat_Driver
Veteran Member
- Joined
- Jan 15, 2008
- Messages
- 2,359
- Location
- Coachella Ca.
- Tractor
- 2016 Kubota 4060, 2017 Tackeuchi excavator TB260
Anyone else have problems with the rear D rings on a dump trailer.
My last two loads with the dump bed all the way up refused to dump because the load was hung up on the two rear D rings.
I couldn't move the obstruction as it was too wedged in and even if I did I would be under an avanlach of debris if I did break it loose.
I had to lower the load clear the jammed piece being stopped by the D- rings and re dump the load.
The line of other people behind me were not happy.
Any solutions besides cutting them out? I do like them there when I move equipment in the dump trailer.
Putting in recessed D-rings would be a pain but if that's all there is?
I'm thinking of fabricating some sort of a metal ramp so when the loads hits the D-ring it might defelct over the ring?
Any ideas would help.
My last two loads with the dump bed all the way up refused to dump because the load was hung up on the two rear D rings.
I couldn't move the obstruction as it was too wedged in and even if I did I would be under an avanlach of debris if I did break it loose.
I had to lower the load clear the jammed piece being stopped by the D- rings and re dump the load.
The line of other people behind me were not happy.
Any solutions besides cutting them out? I do like them there when I move equipment in the dump trailer.
Putting in recessed D-rings would be a pain but if that's all there is?
I'm thinking of fabricating some sort of a metal ramp so when the loads hits the D-ring it might defelct over the ring?
Any ideas would help.
Last edited: