OP
jwmorris
Veteran Member
- Joined
- Oct 3, 2007
- Messages
- 1,058
Dump bed hydraulics
- Thread starter jwmorris
- Start date
- Views: 39830
Dr Dave
Platinum Member
Looks like it works good. You could also add a viborator made from a starter motor and an offset weight.
Dave
Dave
CDN Farm Boy
Veteran Member
Is that a Scout or Early Bronco in the first pic?
OP
jwmorris
Veteran Member
- Joined
- Oct 3, 2007
- Messages
- 1,058
It's a '68 Scout in need of a new home.
The material I had was very dry and dumped about 7 degrees from the limit of the lift. I am not sure how much, if any, installing the steel floor will do to help things out but I could see a problem with wet soil. Dr.Dave do you have one of the vibrators, and or photos?
The material I had was very dry and dumped about 7 degrees from the limit of the lift. I am not sure how much, if any, installing the steel floor will do to help things out but I could see a problem with wet soil. Dr.Dave do you have one of the vibrators, and or photos?
Dr Dave
Platinum Member
Yes I have one, I will try to get a picture tomarrow and post it. They make a polly liner for dump truck beds, it would be lighter than steel, and should be cheaper.
Dave
CDN Farm Boy
Veteran Member
'68 Eh? Those were nice trucks.
You could try a sheet of UHMW plastic in the bottom. Perhaps that's what Dave is talking about. Available in various thicknesses, cuts and drills with standard wood tools.
You could try a sheet of UHMW plastic in the bottom. Perhaps that's what Dave is talking about. Available in various thicknesses, cuts and drills with standard wood tools.
