Diagnostic code reader

   / Diagnostic code reader #1  

Kc8ehd

Gold Member
Joined
Jul 1, 2016
Messages
285
Location
Hinton Wv
Tractor
LS XR4040C
Anyone here by chance know of a code reader that will Interface with the XR4040C
 
   / Diagnostic code reader
  • Thread Starter
#2  
Thinking Nexlink NL-102 may read and reset codes
 
   / Diagnostic code reader
  • Thread Starter
#3  
Wrong plug on the xr4000 series , a standard J1939 plug won't work ...looks more like a Perkins diagnostic port. There has to be an hand held code reader /reset for these tractors without paying $1500 To $3000 .....any ideals ?
 
   / Diagnostic code reader #4  
I've been looking for almost 4 years now. Even if a plug is found that fits I doubt an automotive type reader would read the codes. Unfortunately there isn't much demand for a tractor aftermarket code reader or a standardized OBD II port like the automotive industry. The software also seems to be proprietary per each manufacturer.
 
   / Diagnostic code reader
  • Thread Starter
#5  
Minhinda has a standard obd2 , many other have J1939 standards , have read and reset codes on many types of equipment... notice dealer had a hand held for checking codes ...they wouldnt give me any information on it ...have found some in the $600 dollar range that say the will work on new holland boomer .....that's basically an LS , same part number for the ecu...
 
   / Diagnostic code reader #6  
What ones did you find for $600 range that will work on the boomer? I haven't had any codes but I'd be interested for future reference.
 
   / Diagnostic code reader #8  
I just went out and looked but can't find the data port. Where is yours located?
I pulled both under dash panels and popped the hood but didn't see it.

I have an Autel Maxicheck Pro diag. tool that should be more than capable.
 
   / Diagnostic code reader
  • Thread Starter
#9  
Mine is in the cab under the steering wheel near floor (right of center ) , there is an opening for plug , the cover only has 3 screws for easier access
 
   / Diagnostic code reader
  • Thread Starter
#10  
Will check wireing should be
B= ground
A= +12
G= CANH
F= CANL
This should allow for code read/reset
 

Tractor & Equipment Auctions

2008 John Deere 608C combine head (A50657)
2008 John Deere...
2019 Allmand Night-Lite V-Series S/A Towable Light Tower (A49461)
2019 Allmand...
Toro 30495 Groundsmaster 7200 72in Zero Turn Mower (A48082)
Toro 30495...
WHITE CI-7 DRAW WORKS POWERED BY TWIN DETROIT 12.7S (A50854)
WHITE CI-7 DRAW...
Kraus Drive Over Fertilizer Conveyor (A50514)
Kraus Drive Over...
2011 Ram 1500 4x4 Crew Cab Pickup Truck (A50323)
2011 Ram 1500 4x4...
 
Top