CUB CADET 1641 PROBLEMS

   / CUB CADET 1641 PROBLEMS #1  

GONEFISHIN

New member
Joined
Jun 21, 2004
Messages
1
Does anyone know what the ac voltage should be on the voltage regulator ? I am getting 16 at idle, haven't checked it at max speed.
Also, just bought a new PTO clutch. Why does it turn so hard, you can barely turn it by hand. Doesn't this rob a lot of engine power ? The air gap is correct - 0.017".
 
   / CUB CADET 1641 PROBLEMS #2  
Not sure about the voltage. Sorry.

Possibly the new clutch needs just a bit of "run-in" time to loosen it up. I just got done putting a new field assembly on my 1641 PTO clutch about an hour ago. I set the air gap at .012" just to give a better hookup. Don't go under .010", though. I've never really experienced any lack of power with the tractor. That Vanguard is doggone near impossible to lug down!!
 

Tractor & Equipment Auctions

Wood Table (A53316)
Wood Table (A53316)
2000 Mack CH613 (A53314)
2000 Mack CH613...
2003 Ford F-250 4x4 Reading Service Truck with Liftgate (A53422)
2003 Ford F-250...
Generac Yanmar 5000Watt Heavy Duty Diesel Generator (A54811)
Generac Yanmar...
Steiner VA242 Post Hole Digger (WORKS GOOD) (A50775)
Steiner VA242 Post...
2001 AMADAS 2100 LOT NUMBER 251 (A53084)
2001 AMADAS 2100...
 
Top