Converting my pin on loader to a skid steer quick attach system

   / Converting my pin on loader to a skid steer quick attach system
  • Thread Starter
#31  
Well I had to put the forks to use today :)
Used them to take the Lull cylinder out and rebuilt it today and re installed it. It's 14'-8" long :eek:
This one is taking it out, I wish I could have taken many more but between the rain, grease and humidity and the fact that my daughter was coming for a brake job at noon I didn't really have time.
rqPi4sml.jpg

This one is after the rebuild and getting it ready to go in
h14Sd5ll.jpg
 
   / Converting my pin on loader to a skid steer quick attach system #32  
:thumbsup:
 
   / Converting my pin on loader to a skid steer quick attach system #33  
And so it begins, I finally got around to ordering some pieces to convert my pin on loader to skid steer quick attach system.
The first part of the puzzle arrived today
VSR4MROl.jpg

Where did you fine those SSQA plates?

Hey it looks good.
 
   / Converting my pin on loader to a skid steer quick attach system
  • Thread Starter
#34  
   / Converting my pin on loader to a skid steer quick attach system #36  
I've been looking at those same adapters on ebay. What did you think of the quality are they well built ?
 
   / Converting my pin on loader to a skid steer quick attach system
  • Thread Starter
#37  
I've been looking at those same adapters on ebay. What did you think of the quality are they well built ?

Yep, for 120 bucks you can't go wrong. Just note that when they arrive the handles are not on properly and you will have to change things around to have them right. I believe it makes for a more compact package for shipping.
 
 
Top