I have an outdoor wood boiler. After 8 years the Taco 009 circulator died. I am looking to find an energy efficient replacement. The height it has to pump is around 14 feet, boiler to the basement. I use a heat exchanger so I don't need to pump up three stories. I'm just trying to lower the electric bill some. Anyone know of a good pump for this?
CIRCULATOR PUMP REPLACEMENT
- Thread starter Brimfield
- Start date
- Views: 1013
LouNY
Super Star Member
- Joined
- Jul 4, 2015
- Messages
- 12,267
- Location
- Greenwich, NY
- Tractor
- Branson 8050, IH 574, Oliver 1550 Diesel Utility (traded in on Branson) NH 8160. Kioti CK2620SECH
So the Taco 009 is 1/8 hp and draws up to 1.4 Amps at 115 volts or approximately 160 watts.
To use less energy you would need a smaller motor.
Grunfos has some as small as 1/15 hp.
This link has several different pumps that could be considered;
Circulator Pumps
To use less energy you would need a smaller motor.
Grunfos has some as small as 1/15 hp.
This link has several different pumps that could be considered;
Circulator Pumps
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,993
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Unless you pay a super high per KWH rate, I don't see how 160 watts intermittent running would impact you electric bill all that much. The Taco I have is a 3 speed model and I usually run it on low.
The circulator is not intermittent unfortunately, this is on a outdoor wood boiler circulating 24/7 . It adds up over time, so now that I need to change it I'm looking at the options for a more efficient one.
Thanks for the link and info, good place to start.
ponytug
Super Member
+1 on the Grundfos.
Since you are running a loop, it really isn't up 14', it is about how many gpm that you need/want. Faster will equilibrium the temperatures sooner, but may be less efficient, depending on your heat exchangers.
All the best,
Peter
Since you are running a loop, it really isn't up 14', it is about how many gpm that you need/want. Faster will equilibrium the temperatures sooner, but may be less efficient, depending on your heat exchangers.
All the best,
Peter
dlctcg
Platinum Member
Not sure they will work for your application you would need to check the pump specs but we replaced Taco 007 (and a different model) & are now using the Taco Viridian pumps on our radiant system... super quiet & efficient pump... the ones we have max out at .54 AMPS / .44 Watts
Well I found it Taco Viridian 1816 variable speed 4-44 watts. I even got a cartridge to rebuild it when it goes. I got lucky that it died late march and not in February at - 5* , prime time for my OWB to break down. For now I'll fix it and shut down for the season.