Broken Tractor - Help!

[Poncho]

In woods today mowing shooting lanes and food plots, went over a wind row and came down the other side , hit a lighter tree stump and busted a housing under the tractor. I have a 431 tractor and the housing bolts to the right side of the main chassis and is connected at the end of a long tube that goes to the front of the tractor into what looks like a pump of some sort. The housing is square and bolts on with 3 bolts to the main chassis and looks to circulate hydarulic fluid (which completely leaskied out). I need the housing and the receiver section that bolts to the fron as it also got bent. Don't know what this is housing/unit is called and want to know what I'm into on $$.

Thanks,

 

[WilliamBos]

In woods today mowing shooting lanes and food plots, went over a wind row and came down the other side , hit a lighter tree stump and busted a housing under the tractor. I have a 431 tractor and the housing bolts to the right side of the main chassis and is connected at the end of a long tube that goes to the front of the tractor into what looks like a pump of some sort. The housing is square and bolts on with 3 bolts to the main chassis and looks to circulate hydarulic fluid (which completely leaskied out). I need the housing and the receiver section that bolts to the fron as it also got bent. Don't know what this is housing/unit is called and want to know what I'm into on $$.

Thanks,

Can you get a picture??

www.agcopartsbooks.com/

 

[Poncho]

Will post pic in morning. Thanks

 

[meanmerc]

How ironic, I did the same well almost, a stump came up and bent the bracket that holds a few hydrolic lines on my passenger side underneath the floor board and ripped out the hydrolic line, was so pissed off that I jut parked the tractor and will look at it tomorow, but have a good hunch that it will be quite a few $$$$$..................grgrgrgrgrgrrrrrrr
With a pic we might be able to help you out more, I'm not familiar with the 431....

 

[Poncho]

Well.... here's the damage. I also have a broken stud in the case that I will have to extract.

 

[ray66v]

I also have a broken stud in the case that I will have to extract.

Have you ever tried a left hand drill bit for that?

The last time I had one, the drill bit quickly turned it right out.

 

[Poncho]

that what i was thinking of using

 

[Poncho]

Bump?

 

[teg]

http://www.agcopartsbooks.com/PartsBooksN/Viewer/book.aspx?book=agco/651765

Link above is a bit off... here's the link to the 431 MF.

You have to install Microsoft Silverlight to see the breakdown of the parts diagrams

 

[teg]

Is this the part? oops, no, you said, "right side"... driver's side or passenger side Actually, I can't really tell from the diagram which side it's from...

Edit, got a photo of the tractor, where it came off?