Bad noises

   / Bad noises #1  

redsput

New member
Joined
Dec 5, 2025
Messages
2
Tractor
Ym 220d and branson 4720h
I hit a stump brush hoggin and the shear pin didn't shear. Every still works, but now there's a definite broken or chipped gear sound from the drivetrain. I idled it slow to the ban and parked it. Thoughts on what it may be,and if it's likely worth fixing? At this point I'd be happy to get her going again even if the PTO is in operable. Any experience that could be shared would be greatly appreciated. Ym 220d
 
   / Bad noises
  • Thread Starter
#2  
Note the sound is from the tractor not the brush hog in case I was unclear on that
 
   / Bad noises #3  
Is this sound only when the pto is engaged or constant? making the noise while idling in neutral? Making the noise only when moving? need more detail.
 
   / Bad noises #4  
Are you using a Overrun clutch? That would be a good place to look if so.

Attachments

  • Rear Axle Int. .jpg
    Rear Axle Int. .jpg
    184.2 KB · Views: 120
This should be the same for the YM220-226 Etc...
 
   / Bad noises #5  
Ouch! Felt that in the seat and the pants is my guess! 220 is this it? FB.Market
1765203746377.png
 

Tractor & Equipment Auctions

2017 Toyota Hybrid Camry Sedan (A59231)
2017 Toyota Hybrid...
PENDING SELLER CONFIRMATION  READ BEFORE BIDDING (A56438)
PENDING SELLER...
2019 BOBCAT E32I EXCAVATOR (A59823)
2019 BOBCAT E32I...
(APPROX. 20) 4' X 8' X 3/8" SHEETING (A52706)
(APPROX. 20) 4' X...
2020 CATERPILLAR 246D3 SKID STEER (A60429)
2020 CATERPILLAR...
2014 Dodge Charger Sedan (A59231)
2014 Dodge Charger...
 
Top