Backhoe pin

   / Backhoe pin #1  

shui5612

Silver Member
Joined
Jun 24, 2014
Messages
127
Location
Montreal
Tractor
2013 Yanmar SC2450, 2008 Kubota ZD326, 1986 Deutz 7085
Hello,

Just got around to pulling out a pin that was made 2 years ago for my backhoe,
Original pin was too short since I added a hydraulic thumb to my backhoe and decided to use an existing pin slot in my backhoe.

Long story short, after pulling it out I noticed two indents in where the bucket sits and rubs. The thumb and main bushing don't seem to have worn out the pin.

How concerned should I be?
Should I replace it now or am I still good for a couple of hours?

The eyes of the bucket and pins were 1inch. (Measured by caliper)
Now the eye is around 1.02 on the bucket and 0.94 inches on the pin in the most worn out part.
Should I simply slide a new pin in ? Or wait until the bucket hole expands abit more to weld it up and re-drill the hole as 1inch.

Thanks in advance. All other pins are fine and greased with no wear. Tractor has around 250 hours and the pin has a good 45h of hard backhoe usage.
IMAG1641.jpg
 

Tractor & Equipment Auctions

2022 FORD F-150 LARIAT CREW CAB TRUCK (A51406)
2022 FORD F-150...
2014 ISUZU NPR  BOX TRUCK (A51219)
2014 ISUZU NPR...
Fifth wheel multi use trailer. (A52128)
Fifth wheel multi...
John Deere 4020 Tractor (A50514)
John Deere 4020...
CATALOG IS A GUIDE ONLY!! (A50775)
CATALOG IS A GUIDE...
NEW 2024 LOAD TRAIL 83IN X 14FT Tandem Axle Dump Low-pro Trailer (A52128)
NEW 2024 LOAD...
 
Top