3pt hitch

[Ym1401King]

Re: 3pt hitch (Specs)

So, if I understand what you are saying in your post, Jim, the height from the lift arm ball ends to the ball end on the center link of the cat. 1 3-pt, should be 15", correct? At the center of the ball ends. So, it should be a 26" bottom width, and then at 13", which would be the middle of the lift arm width, up 15" should be the center link ball end.

Aric
YM1401 /w3tcompact/icons/king.gif

 

[Tractors4u]

Re: 3pt hitch (Specs)

You may want to look at a Category 0 lift pin like would go on the implement. I used those size pins on a small Satoh tractor for the same thing you are talking about. See the attached picture.

 

[JimMc]

Re: 3pt hitch (Specs)

The dimensions I gave were for the implement end. The tractor end varies depending on the tractor.