2022 Outlander Max 6x6

[ArlyA]

Arly I hope you're on the mend and I'll take your posting as a sign that you are.
This shaft, I had pictured this when you mentioned this issue last season as one of the front wheel drive shafts. Clearly it's not. Where is the shaft, between the engine/transmission and the front rear axle? Or is this interaxle between 2 rear axles that I thought the rear most axle was chain driven from the front (rear) axle?
Front rear, rear front terms don't make for good reading. I hope you understand this dribble.

Its the front drive shaft, BRP calles it a propeller shaft that it drives the front differential.

 

[airbiscuit]

So this is the new part? It will help how?

 

[ArlyA]

View attachment 829808


So this is the new part? It will help how?

No idea, I didn't see one.

 

[airbiscuit]

You said the photo shows all the parts. The red arrow is pointing to a part. Is that it?

Or is it more like a 1/2" thick hockey puck?

 

[ArlyA]

You said the photo shows all the parts. The red arrow is pointing to a part. Is that it?

Or is it more like a 1/2" thick hockey puck?

View attachment 829809

The kit shows all the part to replace the front propeller shaft. We only needed to take the shaft off to add the limiter.

 

[airbiscuit]

So the limiter is a homemade part that is like a 1/2" washer or hockey puck to limit how far the shaft can slide?

 

[ArlyA]

So the limiter is a homemade part that is like a 1/2" washer or hockey puck to limit how far the shaft can slide?

Its 1/2 thick. He thought that 5/8 thick might have worked but this thickness barley got together. This 1 inch wide plug was put in the rear coupler to limit its rearward movement.

 

[ArlyA]

Here is another photo of him cutting the spacers out.

 

[ArlyA]

taken a few days ago.

 

[ArlyA]

Next time this machines gets into the shop I'm adding some insulation to the beds tool box by the muffler and cut a few holes in it so more air passes through it. Last winter its HDPE cover warped from heat.