Grading 2019 Front Blade Hydraulics

Anonymous Poster · Jan 8, 2001

Just installed the 2019 60" front blade on my 2410. When I turn the blade to the right, and go into fast "dump". or 2nd detent, the blade shoots to the left!!! Its a real pain when finish plowing. Anyone else seen or have this problem.
Rob

Bud · Jan 8, 2001

Rob
I see you put a 2019 blade on a 2410. Did you use a loader valve? I was wondering if you use a lower arm on the 3PH to raise the blade, which means you would probably have no down pressure. Do you have a part# for the lift kit.
Thanks Bud

Anonymous Poster · Jan 9, 2001

The 2019 is a front blade which works off of the "loader" hydraulics only, so the 3pt is not involved in the operation of the blade.

Bud · Jan 9, 2001

Rob
The reason I asked about the blade is because I have the whole setup for a B7100. I want to use the blade, but not the part (lift kit) that connects it to the tractor. That's why I was wondering if you had the regular frame for the blade, or if you attached it to the loader frame. If you have the lift kit I would apppreciate if you could give me the part number.
Bud