180 Mutilplier promblems

[MF300]

Problem: Mutilplier is always in low meaning something not working,
What i have checked: linkage from dash to case- ok; pressure from hydraulic line that routes to cooler= 5-10 psi; talked to local mechanic says no pressure means bad pump; or that the line that runs from pump up to check T on the line broke; so either a couple things to look at now no matter what i have to split the tractor line broke inside casing of tractor, new mutilplier clutch, or hydraulic pump.
Question is the pump that runs the multiplier the same as the the AUX hydraulic remotes or is it the main pump that runs tractor hydraulics



any info well be help full thanks

 

[massey driver]

I hope it's the Multipower your talking about.Yes it's the Aux pump that's used for the Multipower as well as any remote hydralics.Yes is could very well be the line that feeds the Multipowers control valve that could be split.I tried to scan and upload some pics from my manual but it's not working for me yet. .Larry

 

[massey driver]

Here's some scanned stuff from my manual hope it's what you need.Larry:thumbsup:

 

[MF300]

thanks,i just ordered a manual the other day still aint got it in yet, well im going to hope for the line being broke cause when i operate the hydraulic on the aux remotes the seem to have plenty of pressure so maybe that line just is not holding pressure for the multiplier... thanks again for the info