Search results

Calling all diesel experts, I have a B 2100 that's developed a small issue that I'd like to run by you. The tractor starts and runs great, but when I bring the tractor back to idle, the engine drops about 100 RPM two to three times before settling in at 1000 RPM. It almost sounds like load is...

Folks, I have a 1995 Kubota B2100 with an LA 301 loader that the loader has recently began to settle. The bucket is fine, but the loader cylinders settle and it's apparent with a load in the bucket. The loader will settle with the engine running and no load (nothing in the bucket) requiring...

Folks, I have a 1995 Kubota B2100 with an LA 301 loader that the loader has recently began to settle. The bucket is fine, but the loader cylinders settle and it's apparent with a load in the bucket. The loader will settle with the engine running and no load (nothing in the bucket) requiring...

Gotta leaking oil seal on my left front bevel gear case. Oil seeps and drips down onto the inside of the left front tire while she's sitting. I'm getting ready to replace the oil seal/change the front axle oil and would like to solicit any advice about the process. From the looks of things...

I'm looking for a replacment hood for my 2006 GT 2550. A used one would due. Mine melted a couple years ago and I'm tired of the looks. Messicks has 'em, part number 759-04137A, but $268.00, yikes! Thanks, Kubo

I'm looking for a replacement hood, CC party number 759-04137A. Does any body know where I can get one for a reasonable price? I'd settle for a used one. Messicks has them for around 268 bucks, yikes. kubo

While I was dismounting my tractor yesterday, the hammer loop on my coveralls caught on the three point float adjustment knob and did a great job of tearing the plastic up. I have the new plastic ordered, but I'm curious how the end knobs on the three point and 4WD levers come off in order to...

Looking into a block heater install on my tractor. Anybody have any sources for purchase of a good quality, reasonably priced heater? Kubo

Evening, I'm looking for advice on the proper shear bolt for my new 4' rotary cutter that I'm pulling behind my B2100 with 17 pto HP. The bolt being used now is a 3/8" x 3", and I can't tell what grade. Can anyone offer up advice if the 17 HP pto will shear a 3/8", grade 2 bolt, or do I...

I just installed the JD starting improvement kit on my '95 B2100 to help with some occasional starter engagement issues. It works great in this application and is a really easy install. I'm very pleased with the results. I got the tip about the improvement kit from these boards. You folks are...

Hey folks, I'm needing some advice for my '95 B2100. I recently mounted 2-50 watt lights which turned out really well. One flood for the back and the other on the ROPS looking forward. I used the stock worklight circuit on the tractor on the 15 amp fuse. No problems at all and I installed...

Hi Folks, I have a '95 B2100 that's developed a very small oil leak from the joint at the hydraulic pipe and oil filter mount. It looks like it's from the pipe that returns oil to the transmission as it leaves the filter mount. This looks like a simple fix and I have the two O rings which...