Yanmar YFL 1075 loader question

[kempryan28]

I am looking for info regarding an old yanmar YFL loader YFL 1075. Particularly the front left tilt cylinder specs to see if I can find a replacement for it. Center to center pin length, bore, min/max stroke etc. any information you have would be helpful thanks.
I have dropped off the old one at a fluid power shop and suspect they will tell me my rod is bent and making a new one might be expensive... just seeing what’s out there for aftermarket replacement vs repair of the current one. Thanks!

 

[kempryan28]

Or better yet has anyone specifically bought one or delt with an aftermarket company that could help me find the replacement?

 

[bmaverick]

Or better yet has anyone specifically bought one or dealt with an aftermarket company that could help me find the replacement?

YFL1075 fits a YM276 tractor

Have you reached out to Yanmar USA Parts and Service?

I've attached all I know about these ....

 

[California]

A good hydraulics shop can probably straighten that rod.

I was charged $160 for straightening and new seals. Next dribbly seal, I bought the seals for $10 and did the job myself.

My Great Bend (now BushHog) loader takes generic seals available anywhere and I expect yours, likely built by ARPS, does too.

 

[kempryan28]

Thanks guys. Both useful and good information. Onward!

 

[wesmann]

From the YFL 1075 manual

 

[bmaverick]

From the YFL 1075 manual

And now it's complete.

Thanks!

 

[Williy]

If you need any yanmar parts check out these web sites: parts for yanmar YFL loader YFL 1075 at DuckDuckGo

willy