Will not pull on a hill

   / Will not pull on a hill
  • Thread Starter
#11  
   / Will not pull on a hill
  • Thread Starter
#12  
Yeah more information.
Are you suspecting the transmission?
What is the transmission? hydro, manual, "power shift" type?
Just the model # would require most to have look it up and tractors and basically the same with just a few variables, mostly transmission. 👍
 
   / Will not pull on a hill
  • Thread Starter
#13  
Was guessing clutch… but hydro might be cause, just don’t know…maybe clutch is slipping… how to check
 
   / Will not pull on a hill #14  
Was guessing clutch… but hydro might be cause, just don’t know…maybe clutch is slipping… how to check
What color is the tractor?
🤣
Maybe there's a fortune teller or mind reader forum out there, but I'm done with this guessing game.
 
   / Will not pull on a hill #15  
Was guessing clutch… but hydro might be cause, just don’t know…maybe clutch is slipping… how to check

Bad clutch will always slip in higher gears first. Pto will also slow down in sync with tractor slowing down. If engine speed stays the same while tractor and pto are slowing down then your clutch is likely bad. You should have appx 5/8" free play at the top of the clutch pedal. Do you have that?
 
   / Will not pull on a hill #16  
Was guessing clutch… but hydro might be cause, just don’t know…maybe clutch is slipping… how to check
A YM2610/D has a PowerShift transmission. (y)
 
   / Will not pull on a hill #17  
A YM2610/D has a PowerShift transmission. (y)


That is why it is important to check both tractor movement and pto speed. the powershift transmission can slip because of the hydraulic clutches, however, the pto will not slip unless the main clutch is bad or splined couplings/shaft splines are bad. And in that case the pto would likely not turn at all.
 
   / Will not pull on a hill #18  
My 63 Ford has a 2 stage clutch. 1 disc. for the PTO gears another for the main drive. I can disengage the Drive with the clutch pedal and let the PTO stay in operation. As long as I shift the PTO in gear like the YM2000. Nice option!!
 
   / Will not pull on a hill #19  
My 63 Ford has a 2 stage clutch. 1 disc. for the PTO gears another for the main drive. I can disengage the Drive with the clutch pedal and let the PTO stay in operation. As long as I shift the PTO in gear like the YM2000. Nice option!!
I suspect the PowerShift springs.
 

Tractor & Equipment Auctions

2006 INTERNATIONAL 4300 DT466 SBA 4X2 BUCKET TRUCK (A51406)
2006 INTERNATIONAL...
12in Mini Excavator Tooth Bucket (A52377)
12in Mini...
2001 CATERPILLAR 140H VHP MOTORGRADER (A51406)
2001 CATERPILLAR...
2003 International 7400 T/A Heil 12 CuYd Dump Truck (A51692)
2003 International...
2008 JCB 520-40 TELESCOPIC FORKLIFT (A51406)
2008 JCB 520-40...
NEW HOLLAND 706 30 INCH 3PT DIRT SCOOP (A55301)
NEW HOLLAND 706 30...
 
Top