Buty
Silver Member
Planning for my next project but I did not have any rear remotes. First question, What type valve would be best for a TNT?
What valve for TNT?
- Thread starter Buty
- Start date
- Views: 1055
Sysop
Elite Member
- Joined
- Jun 7, 2013
- Messages
- 3,301
- Location
- Fairmont, WV
- Tractor
- Mahindra 4035HST purchased 2013 - Husqvarna TS348-D purchased 2019 - Craftsman 42" HST purchased 2003
You will want at least two sets of remotes for top and tilt both, unless you want to use a diverter valve, then you can get away with a single set of remotes on the rear.
MtnViewRanch
Elite Member, Advertiser
- Joined
- Mar 19, 2005
- Messages
- 10,655
- Tractor
- Mahindra 7520, Mahindra 3215HST, Case 580 extendahoe, Case 310 dozer, Parsons trencher, Cat D6,
I typically recommend that a person get at least one of the valves with the float function, preferably both. And then as long as you are doing this, you might as well get 3 control valves, not that much more money and once you start using hydraulics, you end up wanting more functions to be hydraulic actuated.
Are you sourcing items yourself, or are you going with the Kubota set?
I have a 3 valve set, 2 with float function for $890. That is everything you need to have this operational except the actual valve mounting bracket.
Here is a link to a guy that just finished doing his own setup on his L3800. Very Very nice install. :thumbsup:
Are you sourcing items yourself, or are you going with the Kubota set?
I have a 3 valve set, 2 with float function for $890. That is everything you need to have this operational except the actual valve mounting bracket.
Here is a link to a guy that just finished doing his own setup on his L3800. Very Very nice install. :thumbsup:
