pmsmechanic
Elite Member
- Joined
- Dec 6, 2013
- Messages
- 4,045
- Location
- Southern Alberta, Canada
- Tractor
- 4410 and F-935 John Deere, MF 245
As far as I'm concerned all that greasing a pto shaft does is make it hard to remove. The grease collects dust/dirt and migrates it into the tubes. To the point that you can't move the shaft by hand at all.Not going there. I stated what WD (Water Dispersant) 40 is good for and I'll leave it at that. Every one of my pto sliding shaft inners have grease fittings on them for a reason.
That's when I get a call. Hey can you get my PTO shaft off for me? WD-40 might very well not be a lubricant but it works.