UFO woes part 2

[BrettW]

OK,
(recap: problem is cant make the lift arm hydraulics work, not the 3pt which works fine)
I just changed out the switch that runs my lift arm hrdraulic piston, and no luck. Couldn't get it to do anything. I checked the fuse box again, nothing wrong there either. Made direct connections bypassing the switch, nothing.
So, where do I go from here? Inline fuse somewhere? There are 3 wires going to the switch, the center one was black on the old switch so I put it back in the middle. However, I think that black is usually a ground, correct? Anyway, I crossed the wires every combination and go nothing at all.
Any ideas would be most appreciated
thanks, Brett

 

[YanmarFever]

Brett
Mine tilt only works when the 3 point is in the down position, because there is a little switch in the handle that controls it.
Could your switch have gotten bent, loose, or broke ?
Ernie

 

[YanmarFever]

I was telling a friend that my tractor has a UFO tilt mechanism
you should have seen the look I got from everyone there.
You would of thought I looked like Art Bell. /forums/images/graemlins/shocked.gif /forums/images/graemlins/shocked.gif /forums/images/graemlins/shocked.gif

 

[HoyeTractor]

They are really basic if you dont need the auto level part. If you are just using the joystick then it is just a 3 position switch and 2 electric valves. If you email me with a fax# I will fax you a page out of our owners manual that shows how to eliminate the electronic "self leveling" feature.

Aaron
Parts@HoyeTractor.com
(940) 438-0386