Troybilt horse tiller

[Mazyck]

I bought this tiller unassembled. I'm looking for spec for the engine mount pins. I know they are made from 3/4" round stock with threaded hole in the top, I don't know about the machining mid-way along side for adjusting and holding the pin in the unit. Can anyone help me.

 

[Gale Hawkins]

I think Troybilt is still in business so you may want to check with them tomorrow.

 

[bcp]

You may not need the top hole, unless you have a brush guard. The side has a shallow hole the bolt goes into. It isn't tightened, but is allowed to float a bit.

Bruce

 

[cheeto]

I can measure mine tomorrow.... I would say there is a indentation exactly halway down the shaft that recieves the bolt.

 

[Custom Parts]

Those shafts are available new for $19.95 from us. Let me know if you have specific questions.
Tim