Troybilt horse tiller

   / Troybilt horse tiller #1  

Mazyck

New member
Joined
May 27, 2013
Messages
1
Location
Eaton Rapids, MI
Tractor
Troybilt / Horse
I bought this tiller unassembled. I'm looking for spec for the engine mount pins. I know they are made from 3/4" round stock with threaded hole in the top, I don't know about the machining mid-way along side for adjusting and holding the pin in the unit. Can anyone help me.
 
   / Troybilt horse tiller #2  
I think Troybilt is still in business so you may want to check with them tomorrow.
 
   / Troybilt horse tiller #3  
You may not need the top hole, unless you have a brush guard. The side has a shallow hole the bolt goes into. It isn't tightened, but is allowed to float a bit.

Bruce
 
   / Troybilt horse tiller #4  
I can measure mine tomorrow.... I would say there is a indentation exactly halway down the shaft that recieves the bolt.
 
   / Troybilt horse tiller #5  
Those shafts are available new for $19.95 from us. Let me know if you have specific questions.
Tim
 

Tractor & Equipment Auctions

2012 Caterpillar AT1055E Track Asphalt Paver (A51691)
2012 Caterpillar...
2019 CATERPILLAR 289D3 SKID STEER (A51246)
2019 CATERPILLAR...
2005 Toyota Tundra Limited Crew Cab Pickup Truck (A51692)
2005 Toyota Tundra...
2000 Thomas Built Saf-T-Liner MVP-ER Transit Passenger Bus (A51692)
2000 Thomas Built...
UNVERFERTH 330 - 19-INCH EXTENSION KIT FOR RIP-STRIP TOOLBAR PART # 63186G (A52748)
UNVERFERTH 330 -...
New Wolverine 3pt Receiver Hitch (A53002)
New Wolverine 3pt...
 
Top