kubota352
New member
Tire pressure for water filled rear tires on kubotea m9000 tractor .?
Tire Selection tire pressure
- Thread starter kubota352
- Start date
- Views: 2459
Wolfy
Veteran Member
The tire should say on the sidewall. I do not believe that liquid changes the pressure.
s219
Super Member
- Joined
- Dec 7, 2011
- Messages
- 8,607
- Location
- Virginia USA
- Tractor
- Kubota L3200, Deere X380, Kubota RTV-X
Maximum pressure is listed on the tire, and most people run at that or a little lower. However, the owners manual will have specific recommendations and is the best source of information.
Gary Fowler
Super Star Member
- Joined
- Jun 23, 2008
- Messages
- 11,998
- Location
- Bismarck Arkansas
- Tractor
- 2009 Kubota RTV 900, 2009 Kubota B26 TLB & 2010 model LS P7010
I try to run mine low enough to have some sidewall flex so I have 100% bar tread on the ground. This is usually around 12 PSI on my tractor and depends on how much weight is attached. You should have the heaviest implement on the 3 PH when doing this.
You can check this by running tire thru water and then onto dry pavement to see how much tread is touching (marking wet on pavement). You can also do the reverse on this by just wetting concrete, but not have standing water, and driving the dry tractor tire thru the wet pavement and see how much of the tire gets wet.
You can check this by running tire thru water and then onto dry pavement to see how much tread is touching (marking wet on pavement). You can also do the reverse on this by just wetting concrete, but not have standing water, and driving the dry tractor tire thru the wet pavement and see how much of the tire gets wet.
varmint
Elite Member
- Joined
- Mar 17, 2003
- Messages
- 2,578
- Location
- Northern Maryland
- Tractor
- Kubota B8200, then a Kubota L3130 HST, now a Kubota L3400 HST
Gary, I think that the guy at Everything Attachments mentions that in one of his videos: he put a slip of paper under the tread at the edge while slowly deflating the tire until the paper was caught. Same idea of getting 100% tread contact. Made sense.
