Time for New Carb ?

[Donsyl]

Hey GTSRider i have a 1811 cub and it has a spring loaded screw near top of carb and when i pulled it out and sprayed carb cleaner in there it started running better. I didnt take that out the first few times that i cleaned the carb i dont know why but anyways it seemed to help a lot. I have mowed twice now with no troubles. good luck Don

 

[GTSRider]

Thanks Don.... mine is capped off... but I will need to drill out cap.
I think you are right and this is problem.
Will keep you posted.
Pete

 

[GTSRider]

Ok...latest update on my haunted. possessed 3000 series Cub Cadet.
After 4 months of needing choke to run 1/3rd way up.... today started
her, and engine ran perfect for 2 solid hrs. of mowing with no choke needed !
Bad news.... it now idles oddly, and visably smokes at idle....
What would be causing this engine to smoke at idle.... and it will run on...
this after I just put in new Kohler fuel shut off solenoid....
if I had the $.... I'd buy something new... but the power steering , and lift is a nice feature.
Pete

 

[Soundguy]

rich .

 

[harleyizy]

might be as simple as adjusting the carb. there is both a high speed and idle jets generally on the carb. owner's manual should show proper adjustment procedures.

 

[poneykeg]

GTSRider Just went thru the same deal on my precious 3225. My dealer told me the problem was not the fuel shut-off but the 2 o rings#16 on the #17slow jet on the CC parts. That did stop having the choke at 1/3 closed but It still runs rough,pops a little but after opening the throttle and blade engaged it runs fine. I really have my doubts that contiued running having to choke it if its good for the engine. By the way i just read that Kholer is going EFI on new engines now!!!

 

[GTSRider]

Hey...thanks for the response...I KNOW you hit on my problem..because ,
I recently was having problems trying to replace them and damaged one.
Can you elaborate on #16-17 please ?
Where can I get these ?

 

[GTSRider]

For anyone else with this problem....the O-ring # are 24-153-02-S.
These are the 2 O-rings on the idle jet for the Kehein carb on the
Kohler V-twin. The list for under $3 for the 2....expensive... but when you need them... you need them.
Pete

 

[J_J]

If that is a Kohler 20, maybe this will help.

http://www.kohlerengines.com/onlinecatalog/pdf/tp_2450_c.pdf

Pay attention to the low speed jet setting.

I believe the high speed jet is fixed.