Yanmar has it, John Deere has it I think Kioti 20 series has it., its a win if your box blading or pulling plow or tiller Grading and want to come back to the same height..Oh? What subcompact has a proper position control? Where is the win?
Are you referring to the plastic thing the Deere 1 series has? That's a disappointment at best.
You can build something as simple that will hold better with parts from a hardware store.
I'm not even a Massey fanboy, you've just picked a ridiculous thing to bump an old thread over.
Yanmar has it, John Deere has it I think Kioti 20 series has it., its a win if your box blading or pulling plow or tiller Grading and want to come back to the same height..
I do that with my front mount snowblower and it works fine, no appreciable drivetrain stress. However, with a high inertia implement like a rear mount chipper shredder the engine will die unless the RPM’s are up. There is a throttle lag so trying to immediately give the engine more fuel when the PTO is engaged at low RPM still results in the engine dying. I have to start the chipper shredder at about 2,000 RPM which results in way more of a shock to the system than I’d like.Its recommended that you engage your PTO at low engine RPM's and then raise the throttle once engaged to reduce/minimize system shock & #/stress vs engaging with the engine throttle up high.
Oh? What subcompact has a proper position control? Where is the win?
Are you referring to the plastic thing the Deere 1 series has? That's a disappointment at best.
You can build something as simple that will hold better with parts from a hardware store.
I'm not even a Massey fanboy, you've just picked a ridiculous thing to bump an old thread over.