Swival head for a clam, pulp loader

   / Swival head for a clam, pulp loader
  • Thread Starter
#11  
Brad;
I thought maybe it was built in a hydraulic shop. I'm not that much up on hydraulics to figure how much torque it would take to turn once it is loaded or how many gpm the motor would take.
Sizzami;
would you mind sharing the details of the construction ? Also if its not too much trouble some close up pictures of the motor mount and turning system. How may gpm pump does it take to operate ? This looks very cost effective and dependable. Thanks jr
 
   / Swival head for a clam, pulp loader #12  
8.5 horse 13gpm the swivel for main boom is hydraulic motor on chain, one word of warning if you do it this way buy a hydraulic wheel motor w/ dynamic brake mine has no brake and unit needs to be pretty level to work well I will try to get a couple of pics for you
 
   / Swival head for a clam, pulp loader #13  
pics are coming broke the camera dropped it ran over it tomorrow hopefully
 

Tractor & Equipment Auctions

2017 Ford F-550 Bucket Truck - 4x4, Powerstroke Diesel, Versalift VST47, 52FT Reach (A51039)
2017 Ford F-550...
1989 Freightliner FLD120 (NEW CAT 3406A, NEW REAR ENDS, CLUTCH) (A50397)
1989 Freightliner...
2006 INTERNATIONAL 7600 T/A DUMP TRUCK (A51406)
2006 INTERNATIONAL...
2013 Ver-Mac Solar S/A Towable Trailer Message Board (A49461)
2013 Ver-Mac Solar...
1 guard rail (A49346)
1 guard rail (A49346)
RIGID TOOLBOX (A50854)
RIGID TOOLBOX (A50854)
 
Top