Sickle Mower Hydraulic

   / Sickle Mower Hydraulic #11  
J J
I am a novice in hydro. Is the float in the valve? I will have to add a valve and any thoughts on Fass'e?
Thanks,
Neil
 
   / Sickle Mower Hydraulic #12  
   / Sickle Mower Hydraulic #13  
Some of the jerkiness is caused by the flex of the cutter bar, but it will jerk less if you raise the height of the cylinder mount on the frame because the vertical component of the initial force is lower. Yes this would alter the range of movment of the cutter bar if you don't also change the lower location.
 
   / Sickle Mower Hydraulic #14  
JJ & ZZ,
Higher on the frame and lower on the bar (closer to the pivot)? I need to study my tractor(IH TC 29) and your comments and get back to you.
Many, many thanks,
Best,
Neil
 
   / Sickle Mower Hydraulic #15  
Last edited:
   / Sickle Mower Hydraulic #16  
JJ,
I found an old post that indicated that the IH 1300 could go as much as 70d below level. Not sure if that is posible but certainly is in agreement with you that I have the drop I need.
Thanks,
Neil
 

Tractor & Equipment Auctions

2024 Ford F-350 Super Duty XLT FX4 - Like-New, Loaded, Only 780 Miles (A52748)
2024 Ford F-350...
2001 Dodge Ram Wagon Passenger Van (A51692)
2001 Dodge Ram...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2013 TEXAS PRIDE LAY FLAT HOSE TUGGER TRAILER (A52472)
2013 TEXAS PRIDE...
NEW Slip On Fork Extensions (A53002)
NEW Slip On Fork...
2014 XL SPECIALIZED TRAILER XL 110 HDG RGN (A52472)
2014 XL...
 
Top