tervete
Member
HI, I can't get get the pedal sensors within specs. Does this mean the sensors need replacement?
RE213475 sensor
- Thread starter tervete
- Start date
- Views: 3231
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,660
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
Maybe you could embellish your request with more informative info.
OP
tervete
Member
My Released Position Signal Voltage is 0.6 volts. normal specs are between 0.6-0.9 volts.
My Pressed Position Signal Voltage is 3.9 volts. normal specs are between 2.7-3.5 volts.
My Pressed Position Signal Voltage is 3.9 volts. normal specs are between 2.7-3.5 volts.
OP
tervete
Member
I am getting errors 01 and 02 while driving. I went into the diagnostic mode and found the voltage on the pedal sensors are out of range. I tried for a while and the best I could get are values mentioned above.
OP
tervete
Member
I installed a foam stopper to shorten the pedal travel which enabled me to get the sensors within specs.
Here are some similar links:
