PTO problems

   / PTO problems #1  

Muley Gil

New member
Joined
Jul 19, 2018
Messages
24
Tractor
'49 Ford 8N
Let's try again. My friend's newish JD 1025 is having a PTO problem. There are three positions available. All the way forward is 540, middle is 2100 & 540 and the rearmost position is 2100. When in the rearmost position, the PTO shaft is not spinning.

Thoughts/comments?
 
Last edited:
   / PTO problems
  • Thread Starter
#3  
Back to the top with better info.
 
   / PTO problems #4  
Does the mid PTO spin in the middle when both shafts should be turning?
 
   / PTO problems
  • Thread Starter
#5  
Does the mid PTO spin in the middle when both shafts should be turning?

I'll have to check with my buddy. Presently, he has the PTO cover off, trying to figure out the problem.
 
   / PTO problems #6  
If checking, verify the PTO,s are working correctly in the other two lever positions. I.e. rear 540 only and both 540 & 2100 in mid position.

That should provide some information on if the shift linkage is operational for PTO selection
 
   / PTO problems
  • Thread Starter
#7  
If checking, verify the PTO,s are working correctly in the other two lever positions. I.e. rear 540 only and both 540 & 2100 in mid position.

That should provide some information on if the shift linkage is operational for PTO selection. The PTO works in those two positions.
 
   / PTO problems #8  
Is this newish enough to still be under warranty? If yes I would get the dealer involved before tearing anything apart.

If not under warranty I would look very closely at the shift lever and all the linkage to see if something is preventing it from moving fully and engaging the mid PTO only. I.e. a stick, mud, grass, etc. possibly preventing full movement.
 
   / PTO problems
  • Thread Starter
#9  
Well, my buddy took the PTO apart & everything looked good inside. No chipped gears, nothing broken or out of place. He put it back together & the PTO works in the forward position, the mid position but not in the rear most position.
 
   / PTO problems #10  
Did your buddy confirm the shifting fork movement to engage the different gears in all three positions? Sounds like a shift collar is not being moved properly to engage mid PTO only.
 

Tractor & Equipment Auctions

Heavy-Duty Gooseneck Hay Trailer - Built for Large Bale Hauling (A52748)
Heavy-Duty...
John Deere 6175M (A50120)
John Deere 6175M...
2023 NEW HOLLAND HYDRAULIC THUMB FOR B95D TLB WITH STANDARD STICK (A52748)
2023 NEW HOLLAND...
2008 Ford E-350 Versalift 29N 29ft Bucket Van (A50323)
2008 Ford E-350...
Bad Boy 747cc Outlaw **Does Not Run** (A50121)
Bad Boy 747cc...
74in FEL HD Round Back Bucket (A52748)
74in FEL HD Round...
 
Top