Mowing PTO plastic guard

[Acethe3rd]

If you want to keep the guard on it swap it out for one from Bare-Co.
Bare Co USA - PTO Select Safety Guards

these guards are easy to release and retract and reconnect

Sounds like a plan. Thank you. I am going to check these out.

 

[Acethe3rd]

Had one that was 3 little screws. And the collar rotated so re-aligning the holes back up was super duper fun..

Oh no.

 

[Acethe3rd]

I'll agree with the screwdriver pressure assessment. You'll have to push both sides in at the same time so it will probably take s second person. Those things arre NOT easy to pull back by design.

I was using too many farm words. Back at it tomorrow. Thank you.

 

[kenmbz]

Ace-did you get it off?

 

[Beeenvenue]

If you want to keep the guard on it swap it out for one from Bare-Co.
Bare Co USA - PTO Select Safety Guards

these guards are easy to release and retract and reconnect

I’ve seen them on their website but can’t find anyplace to actually buy them. Any leads?

 

[Tmcbay]

The good (??) news is that it will probably fall apart on its own after a few uses.

I know you are supposed to maintain the guards for safety, but as dangerous as pto shafts are I think the best rule is to not get around it while it's running. I also don't understand why a replacement guard costs over $100, they want people to use them they need to make them reasonably priced

 

[RoyJackson]

I’ve seen them on their website but can’t find anyplace to actually buy them. Any leads?

Type in your zip code (Place Order link)

 

[sandman2234]

I have always heard those things called "Bippie's" and they can be a pain to deal with, as you have found. I understand their use, but when a rotary cutter doesn't have one, I don't go looking for one to put on it!
A sawzall might a little bit of mistake, but I bet you have thought about it a time or two!!
Hope you get it off soon!
David from jax

 

[jcman]

If you want to keep the guard on it swap it out for one from Bare-Co.
Bare Co USA - PTO Select Safety Guards

these guards are easy to release and retract and reconnect

I have three of these safety guards and love them. They make it so easy to connect to the tractor. Flip up the levers, slide the cover back, put on the pto shaft, slide the cover back into place and snap the levers back in place.

 

[Robert walker]

I have three of these safety guards and love them. They make it so easy to connect to the tractor. Flip up the levers, slide the cover back, put on the pto shaft, slide the cover back into place and snap the levers back in place.

So how much did these covers cost? I like the idea of not having to fight the cover being in the way while trying to hook up PTO shaft, they are a pain enough.