Jeez, if it's not one thing it's another. These tractors are like boats. Anyway, I got some good advise on the Bulldog loader I have on my Iseki. Whats going on now is I had purchased a 5 ft finish mower in rough shape. I restored it and went to attach it to the tractor. The problem is the PTO coupler won't slip onto the PTO Shaft. The coupler is pretty weathered and I have a feeling its the corrosion and such. I greased everything up and it just barely starts. Any suggestions on cleaning it up? Or do I just buy a new one?
PTO Advice needed
- Thread starter Marada
- Start date
- Views: 1518
banjodunn
Veteran Member
G'day you can get small toothbrush sized wire brushes for a couple of dollars grab one and some wd and give it a good clean you will prob find after the first use it will free up. Good luck
Jon
Jon
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
Also.. be aware that there is a retainer ball or pin that may be sticking and not allowing you to push the coupler on past about 1/2" or so.
soundguy
soundguy