PTO Advice needed

[Marada]

Jeez, if it's not one thing it's another. These tractors are like boats. Anyway, I got some good advise on the Bulldog loader I have on my Iseki. Whats going on now is I had purchased a 5 ft finish mower in rough shape. I restored it and went to attach it to the tractor. The problem is the PTO coupler won't slip onto the PTO Shaft. The coupler is pretty weathered and I have a feeling its the corrosion and such. I greased everything up and it just barely starts. Any suggestions on cleaning it up? Or do I just buy a new one?

 

[banjodunn]

G'day you can get small toothbrush sized wire brushes for a couple of dollars grab one and some wd and give it a good clean you will prob find after the first use it will free up. Good luck


Jon

 

[cowboy357]

I use the Spray Carb cleaner to clean Mine up , works Pretty good at getting back in there loosining up old grease & surface rust . Followed up with a brush like Jon Mentioned. Bob

 

[Soundguy]

Also.. be aware that there is a retainer ball or pin that may be sticking and not allowing you to push the coupler on past about 1/2" or so.

soundguy