Fallon
Super Member
Ya, I have yet to completely win the hose routing & management war on my install too.
Proud owner of a new owner's manual
- Thread starter nvmyhd
- Start date
- Views: 35293
dustin3207
Bronze Member
They work great for box blades and forks!
OP
nvmyhd
Silver Member
I got the hydraulic fluid and filters done.
The large drain plugs require a 30 mm.
I drained and replaced just shy of 10 gallons.
I was surprised how the drain plugs looked.
Rear plug
Yes there are 2 distinct shavings on that magnet.
Front plug
The front axle I used a crescent wrench and replaced the Teflon tape on the fill and drain plugs.
It was a real pain in the butt to refill it.
I only cycled the hydraulics to purge them, I did not get to drive it around to see how the Kubota fluid works.
The large drain plugs require a 30 mm.
I drained and replaced just shy of 10 gallons.
I was surprised how the drain plugs looked.
Rear plug
Yes there are 2 distinct shavings on that magnet.
Front plug
The front axle I used a crescent wrench and replaced the Teflon tape on the fill and drain plugs.
It was a real pain in the butt to refill it.
I only cycled the hydraulics to purge them, I did not get to drive it around to see how the Kubota fluid works.
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 12,906
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
There should not have been any Teflon tape on that straight thread, the copper gasket provides the seal.
Only tighten enough that it doesn't leak
OP
nvmyhd
Silver Member
The axle only uses pipe treaded plugs with a square head.
OP
nvmyhd
Silver Member
I always wanted pallet forks but good gosh these things are a must have, top of the list first thing type of attachment!!
It just sucks that I only bought them because were moving in the next 2 months to Germany and I needed a way to load my 40x60 shop into a semi trailer for storage.
So sadly I will be selling the XR4046HC to some lucky guy/gal
When we come back in 2-5 years I will be buying a new one by then I think the very few items that LS is missing (RPM matching) will be addressed.
It just sucks that I only bought them because were moving in the next 2 months to Germany and I needed a way to load my 40x60 shop into a semi trailer for storage.
So sadly I will be selling the XR4046HC to some lucky guy/gal
When we come back in 2-5 years I will be buying a new one by then I think the very few items that LS is missing (RPM matching) will be addressed.
charles todd
Gold Member
- Joined
- Apr 18, 2010
- Messages
- 385
- Location
- Louisiana
- Tractor
- LS P7010C, Farmall 504, Allis Chalmers 180, Komatsu PC38UU-2
Well that sucks! Bought an LS cab tractor with cab... Then QA forks, now selling to move overseas. I'm sure a pay raise is in order to buy a bigger LS next time... LOL. Safe moving!
CT
CT
