u276979
New member
Very nice! Did you have any concerns when initially cutting on the tank of explosion/fire etc.? I have an old diesel tank I’d like to convert into two fire pits but have worried about just that.
Propane Tank Back Blade Build
- Thread starter mazzbob
- Start date
- Views: 8214
In my case, I made sure it was empty, aired it out for a week with no valve on it upside down, than filled it with water as I cut it with 4.5" hand grinder. Propane is a lot more volatile than diesel, but I don't know much about it. I googled it a whole lot before I done it. Just be careful, good luck with that project.
harrydarwen
New member
- Joined
- Oct 20, 2022
- Messages
- 19
- Tractor
- Implement Carrier
that will surely help you do some work!
Last edited:
Carl_NH
Elite Member
- Joined
- Apr 5, 2002
- Messages
- 4,011
- Location
- Coastal NH
- Tractor
- 01 Kubota B21TLB, 2010 Ferris 52" ZTR, Cub Cadet 1811, Gravely Super8
Very nice work and craftsmanship on that rear blade build.
Also very nice condition for the 1450 - but the seat suspension is reversed!
I had a 1250 and traded for my 1811 in 1989 - most of the seat suspension the U faces the rear, but I don't know if it makes a difference?
Also very nice condition for the 1450 - but the seat suspension is reversed!
I had a 1250 and traded for my 1811 in 1989 - most of the seat suspension the U faces the rear, but I don't know if it makes a difference?
