Power Trac leaf blower

[jfh28]

I don't know why I didn't think of this years ago......just used some bungee cord to strap on a piece of plywood on the pallet forks then strapped on a gas leaf blower.....the pallet forks will raise and lower as well as tilt and side to side can be accomplished by turning the steering wheel......simple, cheap and effective but does look a little amateurish :laughing: ....ultimate solution would be to attach a seat to the snow plow which has the six way function .......Jack

 

[jfh28]

here's the blower in action

 

[groundcover]

Great minds think alike ! Had to improvise while the flat tire on my zero turn was getting fixed !

 

[MossRoad]

Where's the duct tape?

 

[MossRoad]

:laughing:

Nice jobs fellas. :thumbsup:

 

[jfh28]

that would have required scissors which would have been something to put away :laughing: .......Jack

Where's the duct tape?

 

[jfh28]

I agree :thumbsup: ......Jack

 

[MossRoad]

that would have required scissors which would have been something to put away :laughing: .......Jack

:laughing:

 

[MossRoad]

Duct tape - you don't need scissors if you're not 4-f....

4-F or 4F: Unfit for Service due to a lack of Four Front Teeth

 

[jfh28]

:laughing: I've never had much luck manually ripping duct tape......inevitably instead of ripping across the width it goes length wise leaving me with flapping strips.....same with electric tape.....I wind up with stretched out floppy ends.....I'm just a rank amateur......

Duct tape - you don't need scissors if you're not 4-f....

4-F or 4F: Unfit for Service due to a lack of Four Front Teeth