Once upon a time in the land of Me......

   / Once upon a time in the land of Me...... #31  
You'll need to measure yours... DT vs. HST; L2800 vs. L3400, 2004 vs. 20??

What I would suggest, the top plate can be much larger than what the original top plate is. Plenty of space up there. The rear plate could be a hair larger (width and length) but watch for interference with the 3 point arms going up and down...

I might have missed it, are you welding the crack or replacing the cracked part?
 
   / Once upon a time in the land of Me......
  • Thread Starter
#32  
The trans case is welded and tractor is back together, so I think if I get that toplink reinforcement plate on, might give it enough strength so I dont have to replace the transmission case, this winter I'll find out. I was thinking of going full 6'' wide on the plate and if length and depth is not critical, I'll just take some measurements and pick a number, then find every bolt hole I can find to bolt to. Your HST trans case might be a little different, but a L2800dt is most likely the same as a L3400.
 

Tractor & Equipment Auctions

2018 INTERNATIONAL 4400 SBA 4X2 SERVICE TRUCK (A51406)
2018 INTERNATIONAL...
2014 MACK ELITE LEU613 GARBAGE TRUCK (A51243)
2014 MACK ELITE...
Tree Boom (A50322)
Tree Boom (A50322)
HONDA EB 5000X GENERATOR (A50854)
HONDA EB 5000X...
2017 Harley-Davidson FLHTP Police Electra Glide Motorcycle (A49461)
2017...
2006 GMC C7500 DUMP TRUCK (A51406)
2006 GMC C7500...
 
Top