Once upon a time in the land of Me......

   / Once upon a time in the land of Me...... #31  
You'll need to measure yours... DT vs. HST; L2800 vs. L3400, 2004 vs. 20??

What I would suggest, the top plate can be much larger than what the original top plate is. Plenty of space up there. The rear plate could be a hair larger (width and length) but watch for interference with the 3 point arms going up and down...

I might have missed it, are you welding the crack or replacing the cracked part?
 
   / Once upon a time in the land of Me......
  • Thread Starter
#32  
The trans case is welded and tractor is back together, so I think if I get that toplink reinforcement plate on, might give it enough strength so I dont have to replace the transmission case, this winter I'll find out. I was thinking of going full 6'' wide on the plate and if length and depth is not critical, I'll just take some measurements and pick a number, then find every bolt hole I can find to bolt to. Your HST trans case might be a little different, but a L2800dt is most likely the same as a L3400.
 

Tractor & Equipment Auctions

2014 MACK CXU613 (A50854)
2014 MACK CXU613...
ALL TITLED ITEMS HAVE A $35 TITLE FEE!!! (A50775)
ALL TITLED ITEMS...
2016 Chevrolet Impala LT Limited Sedan (A48082)
2016 Chevrolet...
2012 MACK GU713 DUMP TRUCK (A51406)
2012 MACK GU713...
2010 EVCO SERVICE CO., INC. EVCO SERVICE CO., INC. (A50854)
2010 EVCO SERVICE...
NEVER USED FECON 74in Deck Mulcher FDM74 (A51039)
NEVER USED FECON...
 
Top