Old Victor Torch

[downsizingnow48]

I've got my Dad's old Victor o/a torch and regulator setup (cutting and welding). It is on an oxygen and an acetylene bottle that are also very old but still have gas. I just dragged it out of a back room, it has not been used in decades. I want to see if it still works. I don't have a clue if it is safe though. Can it catch on fire if the seals are bad?

 

[coxhaus]

I have 30 or 40 year old Victor o/a torch setup. It has worked for many years. I have had the regulators rebuilt at my local LWS. They do it inhouse. When my regulators went bad they just started leaking all my gas out. Just don't use any oil or grease around the torch or regulators. I am no pro but I have used Victor for a long time.

The 3 or 4 times a regulator went out they always went out before I lit the torch. They seem to go out when I open the valve and you can hear the regulator leaking plus the gas gauge is going down.

 

[coxhaus]

You do need to be safe with a o/a setup. Don't be scared of using your o/a setup. In both of my welding classes we had to use o/a for cutting steel. The instructor does explain how to use o/a. If you are real worried sign up for a basic welding class. They will get you over the hump.

If your tanks are out of date they will need to be tested or exchanged. If you are real worried you can haul all of it to your local LWS and get them to test it. I had to do this with my first MIG I bought used. I could not get the wire to run right. My LWS checked it out told me someone had mixed parts on the MIG gun that was causing problems. They replaced some MIG parts and my MIG has been great for 10 years.

 

[jaxs]

If you must ask (and you did) ,don't use the rig until someone teach's you the proper way. Providing one know's proper use of o/a torch,you are not at any more risk while lighting it after being out of use than subsequent light ups. As someone stated above,seals,hose,regulators and valves should be checked EVERYTIME rig is used.

 

[downsizingnow48]

Thanks for the advice. I used a torch for welding and flame cutting for several years in my Dad's shop before I went into the service. If this torch had been in continuous use I would have no problem, but setting for decades introduces some unknowns. Probably best to have the setup checked out by the LWS folks. Will call around tomorrow to see what the possibilities are.

I see that new setups are not really too costly, but I would prefer to use his old equipment if I can.

 

[coxhaus]

What brand is it? The American made torches are easy to find parts for. Do you have a picture?

My dad could weld pretty good with a torch. I can't run a puddle like he could. I mainly cut and braze with it.

 

[Peter 315]

From the post I'm guessing Victor ....

 

[coxhaus]

Isn't some of the newer Victor being made outside the US?

 

[Peter 315]

What isn't they are just like every other company some stuff made here some over there...