Oil Filter and oil

   / Oil Filter and oil #1  

Bob_Bainbridge

Platinum Member
Joined
Jun 22, 2004
Messages
768
Location
NE Ohio
I changed the engine oil and filter on my new Cub Cadet 3235 today as recommended at 10 hours first time. I replaced the original filter, which is 2-5/8 long with a Fram PH3614 filter that I use on our 2 Saturns. It is the same diameter and thread but is 3-3/8 long. Does anyone see a problem with this? Also is the Hy-Tran oil Iused in my old CC 1450 suitable for the hyrdrostatic drive on the new tractor? Thanks, Bob
 
   / Oil Filter and oil #2  
I don't believe I'd use a filter that was not recommended, or was not a direct crossover. The internal components and workings may not be compatable with the motor even though it screws on alright.
Your new tractor has a warranty. If the dealer determines an engine failure due to improper lubrication, your out. New engine about 1500.
Same with your hyd. oil and filter. Use what's recommended or it may cost you alot of money.
 

Tractor & Equipment Auctions

2014 Gillig 31+56 Low Floor Passenger Bus (A50323)
2014 Gillig 31+56...
2018 INTERNATIONAL 4400 4X2 EXT CAB SERVICE TRUCK (A51406)
2018 INTERNATIONAL...
2014 Volkswagen Jetta Sedan (A50324)
2014 Volkswagen...
2016 Ford Escape SE 4WD SUV (A50324)
2016 Ford Escape...
PLEASE CHECK BACK!!! ITEMS BEING ADDED DAILY!!!! (A50774)
PLEASE CHECK...
2018 E-Z Beever M12R Towable Brush Chipper (A50322)
2018 E-Z Beever...
 
Top