MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,284
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
My brush hog is directly driven off of the hydraulic motor. It was purchased in 2001.
New Owner 425
- Thread starter TanSprFarm
- Start date
- Views: 2823
smartguyz
Gold Member
- Joined
- Mar 16, 2003
- Messages
- 488
- Location
- Beaverton, Oregon
- Tractor
- JD318, Power-Trac PT425 with scuffed-up green paint.
Actually, isn't there a spindle on the TOP of the brush hog that needs greasing?
-Rob /forums/images/graemlins/grin.gif
-Rob /forums/images/graemlins/grin.gif
OP
TanSprFarm
Member
I was unable to find a zerk fitting so I called the factory. They responded, "No zerk because it is the new model with direct drive." Don't know what "new" means, MossRoads is a 2001. Mine is 2004. In any event, the motor casting mounts directly on the deck. ???
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
I thought I saw where someone replaced the hyd motor on their mower, and even tough it is direct driven, it still turns a spindle which has at least two bearings. If the bearings are not sealed, it will have to be greased about every 8 to 15 hours.
Please correct me if your hyd motor turns that swing blade directly without going through a spindle and bearing assembly
Please correct me if your hyd motor turns that swing blade directly without going through a spindle and bearing assembly
MossRoad
Super Moderator
- Joined
- Aug 31, 2001
- Messages
- 63,284
- Location
- South Bend, Indiana (near)
- Tractor
- Power Trac PT425 2001 Model Year
Here's some pictures of my brush hog disassembled.
Picture of the shaft sticking up through the deck. 3 of 5 bolts installed to hold the hub underneath. The bracket for the motor and the grease zerk at the bottom left in the shadows.
Picture 2 all 5 bolts installed. Arrow pointing out grease zerk.
Picture 3 shows bottom half of love-joy connector on shaft. Rubber star sitting on top of deck waiting to be installed.
Picture 4 rubber star installed.
Picture 5 motor installed onto shaft. It had the other half of the lovejoy connector on the motor shaft already. Motor mounting bolts not installed yet.
Hope this clearly shows what I have. /forums/images/graemlins/wink.gif Is the new one different?
Picture of the shaft sticking up through the deck. 3 of 5 bolts installed to hold the hub underneath. The bracket for the motor and the grease zerk at the bottom left in the shadows.
Picture 2 all 5 bolts installed. Arrow pointing out grease zerk.
Picture 3 shows bottom half of love-joy connector on shaft. Rubber star sitting on top of deck waiting to be installed.
Picture 4 rubber star installed.
Picture 5 motor installed onto shaft. It had the other half of the lovejoy connector on the motor shaft already. Motor mounting bolts not installed yet.
Hope this clearly shows what I have. /forums/images/graemlins/wink.gif Is the new one different?
