need help wiring aux lights

[brown1]

as anyone wire rear aux light? i see there is a fuse for one, is there a wire ran under seat perhaps or somewhere else or should i just use one of the spare fuse slots and run my own wire? thanks in advance for any help and merry christmas to all.

 

[bandaidmd]

if there's a fuse there's probably a wire...somewhere.
On Kubota's the wire is under the fender by the tail lights and comes on with the key so the light needs a switch.

 

[SSdoxie]

There is a power and ground wire wired in already. Look at right rear corner just below the tool box shelf, there are 2 wires with round "bullet" style plug connectors for rear work lights. Wire is hot, no switch, so you need to add a switch with the lights.

 

[brown1]

great thank you

 

[bandaidmd]

amazon has some great LED 27 watt for about $25 each, i have 2 pointed forward and one back.

Actually they have came down in price.

TaoTronics LED Work Light Lamp Off Road High Power ATV Jeep 4x4 Tractor 27W 60 Degree Flood Light - Amazon.com

 

[brown1]

i have them wired and have plowed a couple times, works great thanks for the help.

 

[blake037374]

You have pictures?

 

[brown1]

just a el cheapo from tsc but it gets the job done.. not sure if this will work i am trying to do this from my iphone and im having trouble.

 

[blake037374]

Looking good. Thanks for pictures. You just used some heat shrink butt connectors?

 

[brown1]

there were already butt connectors there so i greased then used them.

 

[blake037374]

Awesome I had butt connectors too. Thanks

 

[bandaidmd]

Actually there called bullet connectors. A butt connector is something you connect 2 bare wires together with.